CARE AND MAINTENANCE
All maintenance should only be carried out by a qualified service technician.
WARNING
Before cleaning or performing any maintenance, remove the battery pack from the tool. Never
disassemble the tool, battery pack or charger. For safe and proper operation, always keep the
tool and its ventilation slots clean.
WARNING
To reduce the risk of personal injury and damage, never immerse your tool, battery pack or
charger in liquid or allow a liquid to flow inside them.
WARNING
Always wear eye protection with side shields or goggles marked to comply with ANSI Z87.1.
Wear a face or dust mask when using the fogger. Failure to do so could result in possible
serious injury.
Draining the tank:
• If there is any liquid left in the tank after spraying,
the tank should be drained before cleaning. Do
not store chemicals in the tank.
• Drain the contents of the tank through the fill
area.
• Always use only a soft, dry cloth to clean outside
of the tank; never use detergent or alcohol.
NOTE: Drain the contents back into the original
container or a suitable replacement container. For
disposal, follow instructions on the product's label
and all local, state, and federal regulations.
Cleaning the fogger:
• Fill the tank about one-third full with clean water. Reinstall the battery pack. Spray until
the tank has been emptied. Make sure to direct the fogger toward an area that will not be
damaged by the spray solution.
• Refill and repeat the procedure with clean water. It may be necessary to rinse the tank more
than once, then drain again as directed above.
• Always use only a soft, dry cloth to clean outside of the tool and tank; never use detergent
or alcohol.
• Allow all pieces to completely dry before reinstalling parts and storing the unit.
6
13