Registration And Assembly - Halo UV-ST Manual Del Propietário

05

Registration and Assembly

See below for details on what you need to do to get started!
Registration & Documentation
Please visit gethalo.com to register your Halo
your vacuum by mailing the Product Warranty Registration Card included in your
Manual. Make sure you indicate the Halo
located on the back, bottom side of the vacuum, beneath the bar code.
One-Step Assembly
• Stand product up-right.
• Gently lift handle and place aluminum tube over main shaft of vacuum.
(see illustration 2)
• Slide aluminum tube down onto shaft of vacuum while holding in the handle
attachment screw.
• Allow screw to pop through hole in aluminum tube.
• Use assembly tool hanging from handle to tighten handle attachment screw.
UV-ST Manual Full012.07.indd 10
Ultraviolet Vacuum online or register
™
serial number printed on the label
™
ILLUSTRATION 1
ILLUSTRATION 2
7
22
21
Handle assembly
12/21/07 8:14:34 PM