Basic Troubleshooting - Halo UV-ST Manual Del Propietário

11

Basic Troubleshooting

We've worked hard to make your Halo
trouble-free and maintenance-free as possible, but in the event that you experience
difficulties, please read through these trouble-shooting recommendations:
Before Troubleshooting: Turn off your Halo
it to cool down. Failure to do so could result in electrical shock or personal injury.
The unit will not turn ON
1. Make sure it is plugged into a wall outlet.
2. Check to see if the plug or cord is damaged.
3. Check for a blown fuse or tripped circuit breaker in the household.
The unit stops running
1. Is the dust filter bag full? Replace if needed.
2. See Overheating Cutoff on Page 11.
The unit has bad dust pick-up
1. Check to see if the HEPA disposable dust filter bag is full. Replace if needed.
2. Adjust the height setting. The brush bar must rest on the carpet for effective cleaning.
3. Brush bar not spinning? Press the ON/OFF button. If it is still not spinning, then
press the BRUSH ON/OFF button directly below the ON/OFF button while the
product is ON. Please ensure that the attachment hatch is firmly closed. The
brush bar cannot be operated while the attachment hatch is open.
4. Brush bar still not spinning? Turn the unit OFF, then press the Reset button on
the bottom corner of the product.
5. Can the brush bar turn freely? Make sure fibers, strings or hair are not wrapped
around the brush bar.
If you continue to have trouble, please contact a reputable vacuum service center or
contact Halo Customer Service at 1-866-638-HALO (4256) or gethalo.com.
™
UV-ST Manual Full012.07.indd 16
UV-ST Ultraviolet Vacuum operate as
™
Ultraviolet Vacuum, unplug it and allow
™
12/21/07 8:14:35 PM