Cutting Sizes: En-6800; Unloader Nozzle-Chute - Nogueira EN-9F3B Manual De Instrucciones

Cutting sizes: EN-6800

Ensiling machine model EN-6800, the cutting sizes are defined by the positioning of the pulley belts,
as shown in the following illustrations.
CUTTING OPTIONS:
HOW TO CHANGE THE CUTTING SIZE
(only in model: EN-6800)
Invert the pulley wheel axle to change the cutting sizes
(fig.42).

Unloader nozzle-chute

The unloader nozzle-chute adjusts the direction of the blast and it turns 360 degrees. To adjust the
nozzle-chute, see the following instructions and figures:
TURNING THE NOZZLE-CHUTE: move the TURNING ARM.
POINTING THE BLAST: move the ACTUATOR.
High Nozzle
22
TURNING ARM
BLAST DEFLECTOR
ACTUATOR
fig43
Instruction manual
BLAST DEFLECTOR
ACTUATOR
TURNING ARM
Low Nozzle
fig41
fig.42
fig44