Tightening The Cutting Adjustment Belt - Nogueira EN-9F3B Manual De Instrucciones

Tightening the cutting adjustment belt

Keep the belts tight enough. The tightness must be enough to avoid slippage of the belt. Remember,
loose belts slip and wear out prematurely. On the hand, excessively tight belts overload the
transmission components, and this can damage them.
Parched or damaged belts must be replaced immediately.
1- After the machine is turned off, remove the belt protective cover (fig.61).
2- Remove the 4 screws C, fastening the transmission gearbox.
3- Stretch the belt(s) by tightening the stretcher screw D.
4- Retighten the 4 screws C and replace the belt protective cover.
BELT PROTECTIVE
COVER
fig.61
SILAGE CHOPPERS
fig.62
29