Replacing Blades; Important - Nogueira EN-9F3B Manual De Instrucciones

Blade / Counter-blade adjustment
Model: EN-6180
There must be about a gap of 0.5 mm, between the blade and the counter-blade.
1- After the machine is turned off, open the housing cover.
2- Remove the screws B fastening the blade bracket.
3- Move the bracket with the blade until there is a gap of 0.5 mm from the counter-blade.
4- Tighten all the screws B again.
5- Repeat the operation on each one of the blades.
6- Before turning on the machine, turn the rotor manually and check if any blade touches a counter-
blade.
7- Close the housing cover.
BLADE
COUNTER-BLADE

Replacing blades

When the blades are damaged or worn out, and it is not possible to adjust them to match the counter-
blade, then they must be immediately replaced. Always replace the whole set of blades, so that the
rotor is not imbalanced. Remove the fastening screws from the blades to take out the blades.

Important!

Model EN-6180
26
Use only original NOGUEIRA blades for replacements.
FASTENING
SCREWS
fig.51
Instruction manual
BLADE
COUNTER-BLADE
Other models
fig.50
fig.52