Sanus VMA401 Manual De Instrucciones página 7

2 Mount the Wall Plate
Solid concrete or concrete block
2-1 Mark the wall
2-2 Drill pilot holes
2-3 Insert anchors and screws
[11]
6901-002141 05
[01]
Insert anchors [11]/[07].
Use the lag bolt [04], washer [06], and anchor [11] to secure the top of the wall plate. Use the #8
screw [05] and anchor [07] to secure the bottom of the wall plate.
CAUTION:
potential injuries or property damage:

Be sure the anchors [11]/[07] are seated flush with the concrete surface.

Tighten the lag bolt [04] only until the washer [06] is pulled firmly against the wall plate
[01].

DO NOT over-tighten the lag bolt [04] or screw [05].
[07]
IMPORTANT: For stacking configurations, stack from the top down.
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!

Mount the wall plate [01] directly onto the concrete surface.

Minimum solid concrete thickness: 203mm (8 in.).

Minimum concrete block size: 203 x 203 x 406 mm (8 x 8 x 16 in.).
CAUTION:
Avoid potential injuries or property damage!

Pilot holes MUST be drilled to a depth of 63.5 mm
a 10 mm (3/8 in.) diameter drill bit.

Never drill into the mortar between blocks.
63.5mm
(2½ in.)
Improper use could reduce the holding power of the lag bolt. To avoid
10 mm
(3/8 in.)
[04]
[06]
[01]
[05]
(2½ in.) using
7