Sanus VMA401 Manual De Instrucciones página 8

2 Mount the Wall Plate
Drywall
2-1 Mark the wall
[01]
2-2 Drill pilot holes
2-3 Insert anchors and screws
[07]
[07]
[07]
8
[05]
[05]
[01]
[05]
IMPORTANT: For stacking configurations, stack from the top down.
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!

Mount the wall plate [01] directly onto the wall.

Drywall must be at least 13mm (1/2 in.) thick.

Do not install anchors into the seam between drywall pieces.
CAUTION:
Avoid potential injuries or property damage!
Pilot holes MUST be drilled to a depth of 38 mm
mm (3/8 in.) diameter drill bit.
38 mm
(1½ in.)
Insert anchors [07]. Then insert screws [05] through the wall plate
[01] and into the anchors [07].
CAUTION:
Improper use could reduce the holding power of the
lag bolt. To avoid potential injuries or property damage:

Be sure the anchors [07] are seated flush with the wall.

Tighten the screws [05] only until they are pulled firmly against
the wall plate [01].

DO NOT over-tighten the screws [05].
10 mm
(3/8 in.)
(1½ in.) using a 10
6901-002141 05