Sweeping Of Flue Pipes To The Chimney; Control Of The Stove; External Maintenance; The Length, Quantity And Quality Of Logs - Jøtul F 400 Instrucciones Para Instalación

ENGLISH

Sweeping of flue pipes to the chimney

It is possible to sweep through the sweeping hatch in the
flue pipe or to remove the top plate and sweep through
the smoke outlet.

Control of the stove

Jøtul recommends that you personally control your stove
carefully after sweeping/cleaning. Check all visible surface
areas for cracks. Also check that all joints are sealed and
that the gaskets are in the correct position. Any gaskets
showing signs of wear or deformation must be replaced.
Thoroughly clean the gasket grooves, apply ceramic glue
(available from your local Jøtul dealer), and press the gasket
well into place. The joint will dry quickly.

External maintenance

Painted products may change color after several years
usage. The surface should be cleaned and brushed free of
any loose particles before new Jøtul stove paint is applied .
Enamelled products must only be cleaned with a clean, dry
cloth. Do not use water and soap. Any stains can be removed
with a cleaning fluid (Oven cleaner etc.).
The length, quantity and
quality of logs
The maximum length of logs to be used is 50 cm. Logs
should be placed parallel to the back wall of the combustion
chamber. Jøtul F 400 has a nominal capacity of 7,0 kW.
According to calculations the nominal heat output will
consume 2,8 kg quality-wood per hour.
Jøtul's definition of quality wood
Good quality wood should be dried so that the water content
is approx. 20-25%.
To achieve this, the wood should be cut during late winter
or early spring. It should then be cut and stacked to ensure
proper airing. The stacks should be covered to prevent them
from absorbing too much rainwater. The logs should be
taken indoors in autumn for use during the winter season.
With good quality firewood we mean logs from trees, such
as birch, beech and oak.
The amount of energy obtainable from 1 kg of wood varies
very little. On the other hand, the specific weight of the
different kinds of wood varies considerably. As an example,
a certain volume of birch will provide less kWh than the
same volume of oak, which has a higher specific weight.
The amount of energy in 1 kg quality wood is approx. 3,8
kWh. 1 kg of completely dry wood (0 % humidity) produces
approximately 5 kWh, while wood with a humidity level of
60% produces only around 1.5 kWh/kg.
36

Service

Replacing the burn plates

• The fireplace has side burn plates, which are fastened
with screws. The rear burn plate is not fastened and is
kept in place by the side burn plates.
• When replacing remove the baffle plate first, then loosen
the screws and remove the burn plates.

Replacing the baffle plate

• Lift off the top plate.
• The baffle plate rests on top of the burn plates.
• To remove the baffle plate, loosen the brackets that
push it down against the burn plates. Use a hammer
and beat them carefully out towards the door. See fig. 5
• Lift the baffle plate a little upwards and remove it
edgeways out through the top.
• For re-installation follow the same procedure in the
opposite sequence.

Optional equipment

Short legs - height 155 mm
Black paint - cat. no. 350173
Blue-black enamel - cat. no. 350174
Ocean green enamel - cat. no. 350328
Ivory enamel - cat. no. 350176