Change Mode From 1Dd To 2L And Vice Versa; Special Function: Short-Term Setting Of A Remote Control - Cherubini A510073 Manual De Instrucciones

CHANGE MODE FROM 1D TO 2L AND VICE VERSA
The Dimmer LED RX with 2 outputs is factory preset for 1D mode.
The mode may be changed from 1D to 2L and vice versa immediately
after turning it on.
To change the 1D Mode to the 2L mode, do the following:
1) Disconnect the power and wait at least 5 seconds.
2) Reconnect the power.
3) Stand by for the Led signal that indicates the current mode:
• 1 blinking for the 1D mode.
• 2 blinkings for the 2L mode.
4) Within 4 seconds press the SET button: the Led shows the new
mode with the relative number of blinkings.
10 sec
...
GB
withing
1D
4 sec
.....
2L

SPECIAL FUNCTION: SHORT-TERM SETTING OF A REMOTE CONTROL

This function makes it possible to store a remote control temporarily. A later
final saving of the remote control will be possible using the appropriate
command sequence (see: "SETTING THE FIRST REMOTE CONTROL"). The
operations described below can be carried out only when the receiver has
just come out of the factory or after a full memory clearing (see: "FULL
MEMORY CLEARING"). The receiver makes the following operations
possible only within the time limits described in order to make sure that
the short-term setting is used only in the installation or factory setting
phase and not during daily use. Power up the receiver, make sure that
no other receivers having an empty memory are powered up in the same
operating range. Within 30 seconds after start, press the B and C buttons
simultaneously until the motor gives a confirmation signal. The remote
control will remain stored for 5 minutes, while the receiver is powered
up. After 5 minutes or when the receiver has its power cut off, the remote
5
control will be cancelled.
1D
T1: First remote control to be set
2L
28
short short long
T1