Focus Mode; Motion Det - Samsung SCC-C4207 Guia Del Usuario

❙

FOCUS MODE

In the FOCUS MODE MENU, the Focus method can be set
to ONEAF(One Auto Focus), or MF(Manual Focus).
✔
ONEAF : In the ONEAF mode, it automatically sets the
focus after the zoom moves, and operates as the
same in the MF mode if the zoom does not move.
✔
MF : You can manually adjust the focus.
CAMERA ID
IRIS
SHUTTER
AGC
WHITE BAL
FOCUS MODE

MOTION DET

COLOR/BW
PRIVACY
SPECIAL
PRESET
EXIT
❖ The ONEAF setting can be selected only when OFF,
1/100(1/120)~1/10K, AUTO X2 is selected for the SHUTTER
menu. Any Other SHUTTER setting(AUTO X4~AUTO X160)
causes MF to be selected automatically for the FOCUS
MODE menu.
❖ ONEAF function may not possible withe types of objects listed
below. For such objects, focus manually.
- High intensity objects or objects illuminated with low lighting
- Obejects shot through wet or dirty glass
- Pictures that are a mixture of distant and nearby objects
- White alls and other single-color objects
- Venetian blinds and other horizontally striped objects
❙
MOTION DET
MOTION DET detects any motion. Set up this function
during no human movement to detect break-in. Once
detected, an ALARM signal will be given for 5 seconds. As
MOTION DET detects any motion, so it can set up the
motion detection sensitivity. Select ON... and press [ENTER]
and the MOTION DET submenu screen will appear.
23
OFF
ALC...
OFF
LOW
ATW1
ONEAF
OFF
COLOR...
OFF
...
...
QUIT
CAMERA ID OFF
IRIS ALC...
SHUTTER OFF
AGC LOW
WHITE BAL ATW1
Press the
FOCUS MODE ONEAF
MOTION DET ON... ENTER
COLOR/BW COLOR...
button.
PRIVACY ...
SPECIAL ...
PRESET ...
EXIT QUIT
If you select ON and press the ENTER button, the MOTION
DET screen will come up. You can set the AREA to which the
Motion Detection function will be applied to either PRESET or
USER. If you set the AREA option to PRESET, the Motion
Detection function will be applied to the areas preset as factory
defaults. If you set the AREA option to USER and press the
ENTER button, you can change the area size and position and
select the area where you want to apply the Motion Detection
function. You can specify the size of the area by using the UP,
DOWN, LEFT, and RIGHT buttons. If the area is not flashing,
press the ENTER button. When the area starts flashing, use the
UP, DOWN, LEFT and RIGHT buttons to specify the location of
the area. Use the ENTER button and the UP, DOWN, LEFT,
and RIGHT buttons to specify the size of the area and to
position the area. Press the ENTER button again to exit the
AREA setting menu. You can use the SENSITIVITY option to
set the motion detection sensitivity. The higher the setting, the
more sensitive the motion detection.
(MOTION DET)
Press the
ENTER
button.
AREA USER...
SENSITIVITY L---I---H
RET
❖ MOTION detection function operates based on the
brightness change within the setup region. Therefore,
erroneous operation may occur depending on the brightness
difference between the background and the object that is
being taken, or the status of the area setup, etc.
(MOTION DET)
AREA PRESET...
SENSITIVITY L---I---H
RET
E
SIZE
LOCATION
24