Fein KBM32Q Manual De Instrucciones página 12

3 41 01 011 21 0.book Seite 12 Montag, 8. Februar 2010 11:51 11
en
12
Changing the tool.
Secure the power tool with the clamping strap supplied if there is danger of it fal-
WARNING
ling, especially for work carried out at a height, on vertical construction elements
or above the head. If there is a power cut, or the mains plug is pulled out, the magnetic holding
power is not maintained.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Core drill bit (Figure 4).
Insert the centering pin into thee core
drill bit.
Turn the QuickIN clamping sleeve of
the tool holder leftward and insert the
core drill with the centering pin.
Release the QuickIN clamping sleeve
and turn the core drill in the tool holder
until the lock engages.
Do not touch the sharp edges of the core drill
bit. Danger of injury.
Core bits and core drills with
M 18 x 6 / P 1.5 (Figure 5).
Screw the adapter onto the key-type
drill chuck.
Turn the QuickIN clamping sleeve of
the tool holder leftward and insert the
adapter in the same manner as a core
drill.
The adapter can also be used for suitable core
drills.
Fig. 4
Core drill bit
Fig. 5
QuickIN
adaptor
Centering pin
Adapter
Key-type
drill chuck