Publicidad
Fig. 3
Ac
Ac
3. Spread a thin film of glue in the dowel holes in the Left Leg Assembly (Lc). Insert dowels of
back/seat assembly and wipe off excess glue with a damp rag. Using the provided Hex Wrench (Kc),
secure the Left Leg Assembly (Lc) to the Back, Seat and Apron with 7x70mm Hex Screws (Ac).
See Figure 3.
J
4. Secure outer seat braces to Left and Right Leg Assemblies (Lc & Mc) using 6x40mm Hex Screws
(J). To attach the Seat (Pc) to the Front Apron (Oc), insert a 4x40mm Phillips Head Screw (B)
through the pilot hole in the center brace, making sure it is fully seated into the Front Apron. To
attach the Seat (Pc) to the Back Assembly (Nc), insert a 4x40mm Phillips Head Screw (B) into the
remaining hole in the center brace of the Seat (Pc), making sure it is fully seated into the Back
Assembly.
Tap Metal Pin (H) into the hole near the bottom in the inside front edge of the Left and Right
Leg Assemblies (Lc & Mc). These pins act as a stopper for the Rocker Arm (I) and to prevent the
glider from tipping too far backwards.
Ac
Lc
B
B
J
J
J
H
Fig. 4
H
Ac
Kc
J
Kc
B
961KFSIc – Page 4 – 10/08
Publicidad
