Cleaning Or Replacement Of The Product Filter - Elcometer SAGOLA 4600 XTREME Manual De Instrucciones

38/39
Replace the gasket with the one supplied with the battery in
Kit 56418440. Fit the new gasket in the plug and fit both in
the gun, closing the housing hermetically.
Environmental damage by depositing the
battery you have repaced in the battery recy-
cling container.

12.3. Cleaning or replacement of the product filter

If there is any cleaning liquid or product remaining in the tank, return it to its corresponding
containers. To avoid any spillage, keep the pistol in a vertical position and clean as thoroughly
as possible.
Holding the pistol firmly by the handle, disassemble the tank by unscrewing
it from the body of the pistol.
Extract the product filter (No.29) and if there is any cleaning liquid or product
remaining in the body of the pistol, return it to its corresponding container.
Clean or replace the product filter as needed, taking into account that the impurities will cause
defects in the finish and/or obstructions..
Assemble the product filter again, inserting it all the way into the hole in the input connector.
Fit the tank by screwing it firmly onto the body of the pistol, to avoid product leaks.
Tighten the filler cap firmly.
In the version with the non-drip cap, tip it forward (paint up) or back (paint down) as necessary.
Check there are no leaks.
ENGLISH