Monogram ZX8D13SPXX Instrucciones De Instalación página 2

HOOD COMPONENTS
A - Range Hood
B - Screws 3.1 x 9.5 P013 (10)
C - Lower Duct Cover (1)
D - Upper Duct Cover (1)
E - Wall Anchors (4)
F - Wall Bracket (2)
G - Screws 4.2 x 44 PZ1 (4)
D
C
A
INSTALLATION OF DUCT COVER KIT
1. Finish hood installation as per the hood install
instructions.
2. P lace wall bracket (F) against the back wall so that
the top edge is 1/16" from the ceiling and level.
Align the center of the bracket with the center
line of the hood and mark bracket holes. Use the
outermost bracket holes to secure to wall. Remove
the bracket and drill 2 clearance holes for wall
anchors with 1/16" drill bit. Install the wall anchors
(E) and secure the bracket to the wall using screws
(G).
2
Installation
INSTALLATION OF DUCT COVER KIT
(CONT.)
3. Measure straight down a distance (X) from the
bottom of the first wall bracket and make a
horizontal mark. Place the second wall bracket (F)
above this mark and align the center of the bracket
with the centerline of the hood. Mark bracket holes.
Remove the bracket and drill 2 clearance holes
for wall anchors with 1/16" drill bit. Install the wall
anchors (E) and secure second wall bracket to the
wall using screws (G).
F
G
E
B
4. S ecure the upper duct cover to the wall bracket
using 4 screws (B). Refer to the installation height
tables to verify available ceiling heights.
5. P lace the lower duct cover on top of the hood.
Slightly spread the sides of the cover apart and
snap to the upper duct cover. Secure the lower
duct cover to the hood body from inside the hood
using 6 screws (B) at locations shown below.
Ceiling
x
C L
Duct Cover Kit
8' Kit
10' Kit
12" Kit
1/16"
"X"
3"
15-1/2"
25-1/2"
31-2000879 Rev. 0