Publicidad
Step 16
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (40MA) to the PEDESTAL ENDS (A and B). Use four
GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find
the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the FILE DRAWER.
40MC
Push the black lever in and pull the SLIDE from the RAIL.
MOLDING
CONNECTOR
Open end
Page 22
4
3
B
2
1
V
40MA
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
2
A
3
4
Open end
1
W
Publicidad
