Maintenance Plan; Additional Instructions; Decommissioning And Dismantling - Eurosystems MSP 02 Manual De Uso

ment. Doing so can damage the motor
and any electrical systems or batteries.
CAUTION!
Avoid excessive use of water near labels.
In the event of damage, labels must be
replaced before using the machine and/
or the interchangeable equipment again.
Checking the tightness of
fasteners and guards
Cleaning
Cable adjustment
Motor
No fuel; top up.
Check the position of the accelerator.
Check that the spark plug cap is properly inserted.
The motor does not
start
Check the conditions of the spark plug and clean or replace if necessary.
Check that the fuel cock is open (only for motor models for which the cock is
provided).
Air filter dirty, clean it.
Motor power
decreases
Short tool, increase tool height.
Adjust the tool wire insertion.
Tool is not
rotating
Check the tool to be fasten to the shaft.
Contact the nearest authorised service centre if the problem cannot be solved.

14. ADDITIONAL INSTRUCTIONS

14.1 DISPOSAL
At the end of its life cycle, the product
must be disposed of in accordance with
the regulations in force for Differentiated
waste disposal and cannot be treated as
simple urban waste.
The product must be disposed of at ded-
icated collection points or must be re-
turned to the dealer if you wish to replace
the product with another new equivalent
product.
The product is composed of non-biode-
gradable parts and substances that can
pollute the surrounding environment if not
properly disposed of. In addition, some of

12. MAINTENANCE PLAN

Always before starting the machine - check that there are no untightened
screws, bolts and/or nuts and that the bonnets and protection systems are
intact and correctly fitted.
After each use
If operation is not as according to the manual
See specific manual
13. TROUBLESHOOTING
Possible cause
these materials can be recycled to avoid
environmental pollution. It is everyone's
duty to contribute to the health of the en-
vironment.
When present, the symbol
the electrical and electronic equipment
that must be disposed of separately as
prescribed by standards 2002/95/EC,
2002/96/EC and 2003/108/EC. Do not
dispose of this equipment in unsorted
municipal waste, but take it to appropriate
separate collection areas.
Ask your local authorities for information
about waste disposal areas.
Anyone who does not dispose of the prod-
uct in accordance with this paragraph is
responsible for it in accordance with the
regulations in force.
How often
The decommissioning and dismantling of
identifies the Machine and/or the interchangeable
equipment covered by this user's manual
consists in the disassembly of the prod-
uct by authorised personnel in compli-
ance with the provisions of Legislative
Decree 81/08 (use of PPE, etc.) and the
subsequent sorting and disposal as re-
ported in the "DISPOSAL" paragraph of
this Use and maintenance manual.
See chapt.
-
11.
10.1
See chapt.
-
7.6.
Specific motor
manual
Specific motor
manual
Specific motor
manual
Specific motor
manual
7.3.
10.1.
-
14.2 DECOMMISSIONING
AND DISMANTLING