marklin 60652 Manual De Instrucciones página 13

Setting Other Locomotive Parameters
The setting only works with mfx locomotives or locomotives with a
decoder that can be set with data. In some cases, these decoders
only have some of the following possibilities for setting parameters.
Possible Settings:
VMAX – Maximum Speed
ACC – Acceleration
DEC – Braking Delay
VOL – Volume
PRESET – Return the locomotive decoder to the factory
default data
Important: Do not confuse the "PRESET" for the locomotive
decoder (submenu EDIT LOC) with the "PRESET" for the Mobile
Station (submenu OPTIONS).
1. Press the Menu/ESC button.
2. Turn the speed control knob until "EDIT LOC" appears
in the display.
3. Press on the speed control knob.
4. Turn the speed control knob until "VMAX", "ACC", "DEC",
"VOL" or "PRESET" (depending on the desired change)
appear in the display.
5. Press on the speed control knob.
6. The menu symbol will appear in the display and a setting bar
beneath it. Turn the setting bar on the speed control knob
without changes. Small bar: lower maximum speed, shorter
delay, etc., a longer bar means the opposite of the various values.
7. Press on the speed control knob to accept the new setting.
Under no circumstances is the power supply to be interrupted in
the period of time that comes after this ("PROG" in the display).
(=> Appendix M)
Difference in the submenu RESET starting at Step 6.
6. The confirmation question "PRESET?" will appear in the dis-
play. Press on the speed control knob: PRESET is carried out.
Under no circumstances is the power supply to be interrupted in
the period of time that comes after this ("PROG" in the display).
Using a Second Mobile Station
A second Mobile Station can only be connected to the system
with an adapter cable (item no. 610 479). The connection
socket for the second Mobile Station is the center socket on
the connector box.
Important: Technical designation for the main controller
(left socket): Master
Designation for the second controller: Slave
Connections: => Appendix N
After the system is turned on:
The second controller receives data from the main controller
(locomotive list). The second controller's locomotive list cannot
be accessed in this situation.
The second controller is shown in the display with a symbol.
A locomotive already in use by one controller cannot be called
up on another controller.
No operation is possible with a Master controller.
Always use the Mobile Station with the greater output current
(1.9 amps instead of 1.2 amps) as the master controller.
Never use several 24088 feeder tracks or 60115 con-
nector boxes.
Caution: No external voltage ever must be applied to the
track to which the Mobile Station is connected. As such,
it is not permitted to install a junction point to another
operating system (alternating voltage, Märklin Digital etc.).
(=> Appendix O)
Caution: The transformer for the Mobile Station may not
be used to simultaneously power accessory articles.
These require a separate transformer.
Error Display
Indication Description
ADDR.USED Locomotive address iden-
tical with another entry in
the locomotive list. In this
situation the locomotive is
present in the locomotive
list but without any possi-
bility of accessing it.
LIST FULL The locomotive list has
the maximum number
of entries.
LOC USED The desired function
(example: deleting a loco-
motive from the locomotive
list) can not be done,
since the locomotive still
has an operating com-
mand greater than 0.
What to do
– Change address.
– Delete locomo-
tive from the
locomotive list.
– Delete locomo-
tive(s) from the
locomotive list.
– Return to the
operating level
and stop the
locomotive.
13