Set-Up Before Use; Telescopic Pole Connector Assembly; Telescopic Pole (Not Included) Assembly; Specific Telescopic Pole (Not Included) Assembly - Kokido TELSA 30 Manual De Usuario

Set-Up Before Use

Telescopic pole connector assembly

Press down the side pins of the connector and insert it inside the main body. Turn the
connector in either direction until the pin is secured in the hole, as shown in the
diagram .
Telescopic pole assembly
Note: a V-clip is installed inside the pole connector to secure the telescopic pole (not
included) in position. Slide the telescopic pole onto the pole connector. Press on the
side pins of the connector and slide the telescopic pole further down until the pins of
the connector are secured inside the holes of the pole.
To release the telescopic pole, press down the side pins simultaneously and pull out
the pole.

Specific Telescopic pole (not included) assembly

Insert the end (with two side pins) of the pole connector into the pool vacuum as
shown until its side pins are secured to the handle's locking hole on the rear body. To
install the telescopic pole (with internal wishbone clip) to the pole connector as
shown:
11