DENTAURUM Master 3000 Manual Del Usuario página 40

2. Push the plugs of the hand electrodes into
the outlets  and .
3. Turn power switch  to position "I".
The mode last set is displayed.
4. Press pad  to select the "Welding" mode.
The LCD display now shows "Welding" and
the last figure set, e. g. 50.
5. Set the desired welding energy using the pad
 or . The figure selected is displayed in the
LCD display. The welding energy can be set in
steps from 01 to 88. If one of the pads  or 
is pressed for longer than 4 sec the steps are changed faster.
6. Clamp a notched electrode REF 081-501-00 into each of the clamping sleeves of the manual
electrodes and then touch the workpiece with the notched tips at a short distance from the
welding point. The notches of the electrode prevent it from slipping off the wire element.
7. Activate the welding pulse with the manual button  or foot switch. 2-3 welding pulses are
enough to create a perfect welded joint.
8. After completing the welding process, turn the unit off and turn the power switch  to
position "0".
i
Note
When welding with the hand electrodes, the welding power must be set higher than
with the "click-stop" holder. The weld-thickness setting depends on the cross section of the
material being welded. (See separate table, p. 52ff).
Recommended accessory:
Connect foot switch REF 080-116-00 to outlet 
W E L D I N G

5 0


master 3000  en
EN EN

38