Commissioning - Abicor Binzel ABICOOLER 1300 Manual De Instrucciones

6 Commissioning

6 Commissioning
Electric shock due to defective cables
Damaged or improperly installed cables can lead to fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Damaged, deformed or worn parts should only be replaced by a qualified electrician.
Risk of injury from hot coolant
If the coolant tank is opened during or immediately after operation, coolant may spray out and cause
burns or irritation to skin and mucous membranes.
► Keep the coolant tank closed during operation.
► Wait at least 5 seconds after switching off before opening the screw cap of the coolant tank.
► Check and wear your personal protective equipment.
HINWEIS
Material damage due to contaminated coolant
Contamination in the coolant can lead to damage and increased wear in the device.
► Keep the coolant tank cap closed.
► We recommend that you use a coolant filter (not included in the scope of supply).
HINWEIS
Material damage due to a lack of coolant
If there is insufficient coolant, the device's pump can overheat and cause irreparable damage.
► Ensure that coolant is added to the device before commissioning it.
► Ensure that the device is bled during commissioning.
► Ensure that the coolant pump does not run dry.
► Observe the fill level indicator on the device.
► Use the flow control to continuously monitor the proper function of the entire cooling system. If the flow
HINWEIS
Material damage when bridging multiple devices
The use of several devices (in sequence or in parallel) can result in material damage.
► Do not bridge the device with other cooling units.
EN - 10
WARNUNG
WARNUNG
rate is too low, the flow control instigates the immediate switch-off of the connected devices and
prevents thermal overload.
ABICOOLER 1300
Place the handles on the device.
1
Fix them with (4) screws and install the device in
2
a suitable place.
 Tab. 2 Ambient conditions for transport,
storage and operation auf Seite EN-9