Receiving; Channel Group Selection - JOPIX MARINE 515P Manual De Instrucciones

● Choose low power for short range communications; choose high power for long distance
communications.
● Some channels are for low power communication only.
2. Hold down [PTT] to transmit, and then speak into the microphone.
● "TX" appears.
● Channel 70 cannot be used for transmission.
3. Release [PTT] to receive.
Notes:
- Transmitting without antenna can damage the transceiver.
- Activate TOT function by PC programming software, and then it will limit long
time continuous emission.
- 5-10 cm between month and microphone and speak at a normal voice level.

9.4.2.- Receiving:

1. Adjust the volume levels by push [▲] or [▼] key in volume adjusted mode.
2. Set the squelch levels by push [▲] or [▼] key in squelch adjusted mode.
● When receiving a signal, "BUSY" appears and audio is heard from the speaker.
● The transceiver has power save function, automatically activates when no signal is
received for 5 seconds.

9.5.- CHANNEL GROUP SELECTION:

This transceiver is pre-programmed with USA, International, Canadian channels. Choose
the appropriate channel groups for your operating area.
1. Push [CH] to select a regular channel.
● If weather channel appears, press [CH] again.
2. Hold down [CH] for 1.5 seconds, to select USA, International, Canadian channel group
in sequence.
3. Push [▲] or [▼] key to select a channel.
"DUP" appears when a duplex channel is selected; "A" appears when a simplex channel is
selected.
English - 14 -