DeWalt DXCMWA5591056 Manual De Instrucciones página 28

CODE POSSIBLE CAUSE
Engine or pump oil is low
23
24 It is normal for some pressure drop to occur
25 Damaged regulator
26 Detergent type oil being used in pump
Extremely light duty cycles
27
Piston rings damaged or worn
28
29 Cylinder or piston damaged or worn
30 Compressor cylinder finish worn
31 Water in pump oil
32 Manual lock unloader lever in open position
33 Regulator open
34 Engine fuel tank empty
POSSIBLE SOLUTION
Add D WALT synthetic compressor oil to pump. See Compressor
e
Pump Oil under Maintenance.
If there is an excessive amount of pressure drop when the
accessory is used, adjust the regulator as instructed in
Regulator under Features.
NOTE: Adjust the regulated pressure under flow conditions while
accessory is being used.
Replace.
Drain oil and refill pump with D
Run unit for longer duty cycles. It is recommended to run at high
throttle 50-75% of the run time and idle for 25% of the run time.
Contact a D WALT factory service center or a D
e
service center.
Contact a D WALT factory service center or a D
e
service center.
Contact a D WALT factory service center or a D
e
service center.
Drain oil and refill pump with D
Rotate manual lock unloader lever to the closed perpendicular
position.
Rotate the regulator knob counterclockwise to its built-in stop and
push knob in to lock in place.
Add gasoline, see engine's instruction manual for correct
procedure.
28
WALT synthetic compressor oil.
e
WALT authorized
e
WALT authorized
e
WALT authorized
e
WALT synthetic compressor oil.
e