Nice MC200 Instrucciones Y Advertencias Para La Instalación Y El Uso página 15

WARNING! - To be able to run Procedures A, B, C, D, F, the control unit's memory must be unlocked. If it is locked, run
Procedure G to unlock it.
PROCEDURE A - Memorising ALL buttons of a single transmitter (STANDARD mode or Mode 1)
01. On the control unit: press and hold button T2 until the "radio" LED lights up; then release the button.
02. (within 10 seconds) On the transmitter to be memorised: press and hold any button and wait for the "radio" LED to emit 3(*) long
flashes (= memorisation completed correctly). Lastly, release the button.
03. Note - After the 3 long flashes a further 10 seconds remain to memorise an additional transmitter (if desired), starting from Step 02.
At the end of the procedure, the transmitter buttons will be paired with the commands specified in the Mode 1 description (Paragraph 5.4.1).
PROCEDURE B - Memorising a SINGLE BUTTON of a transmitter (CUSTOM mode or Mode 2)
01. From the table below choose the command to be paired with the relevant button to be memorised.
Choose the command
1 - Up
2 - Stop
3 - Down
4 - Step-by-Step
02. On the control unit: press and release several times button T2, as indicated near the command chosen in the above table.
03. (within 10 seconds) On the transmitter: press and hold the desired button and wait for the "radio" LED to emit 3(*) long flashes (=
memorisation completed correctly). Lastly, release the button.
04. Note - After the 3 long flashes a further 10 seconds remain to memorise an additional button (if desired), starting from Step 01.
(*) - Notes to Procedures A and B:
The "radio" LED can also emit the following signals:
– 1 fast flash, if the transmitter is already memorised.
– 6 flashes, if the transmitter's radio coding is not compatible with that of the control unit's receiver.
– 8 flashes, if the memory is full.
––––––––––––– PROCEDURES –––––––––––––
To memorise the command... (Step 02)
...press button T2 once.
...press button T2 twice.
...press button T2 3 times.
...press button T2 4 times.
English – 14