Testing And Commissioning - Nice MC200 Instrucciones Y Advertencias Para La Instalación Y El Uso

6

TESTING AND COMMISSIONING

These are the most important phases in the automation's arrangement to ensure maximum system safety.
They must be carried out by a qualified and expert technician who must define the necessary tests to verify the solutions adopted to counter
any risks present, and check compliance with laws, regulations, standards: in particular, all the requirements of the EN 13241, EN 12445 and
EN 12453 standards.
Any supplementary devices must undergo specific testing to verify their operation and correct interaction with the MC200 control unit. Refer to
the respective user manuals.
6.1 - Testing
The testing procedure can also be performed as a periodic check of the automation devices. Each component of the system (sensitive edges,
photocells, warning lights, etc.) requires a specific testing phase; for these devices, observe the testing procedures described in the respective
instruction manuals. Run the test as follows:
01. Ensure that all specifications in the "WARNINGS" chapter have been strictly observed
02. Using the control button or the transmitter, command the door Closing and Opening manoeuvres. During these movements, make
sure that a) the photocells (if present) intervene during the Closing manoeuvre; b) the sensitive edge (if present) intervenes with the
set mode; c) that the automatic re-closing of the door (if programmed) occurs in the closing direction. If the results of the tests do not
conform to the requirements, make sure that the electrical connections have been made correctly. In particular, refer to the warnings
stated in Paragraph 4.3.
03. Perform several tests to verify that the door moves smoothly, identifying any assembly or adjustment defects and points of excessive
friction.
04.
Verify the correct operation of each safety device present in the system (photocells, sensitive edges, etc.).
05. Check the operation of the photocells (if present) and any interference with other devices:
1 - insert a cylinder (with diameter 5 cm and length 30 cm) between a pair of photocells, first next to the TX photocell then next to the
RX photocell, to interrupt the line of sight between them;
2 - verify that this causes the intended action in the control unit: for example, the inversion of movement during the closing manoeuvre.
17 – English