On/Off Switch - BaByliss PRO FXX3T Instrucciones De Operación

SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
1. Before using the trimmer for the first time, charge continuously for 4 hours. Maximum battery
capacity will only be reached after 3 charging and discharging cycles.
2. Make sure the switch on the trimmer is in the OFF position. Connect the charging jack into the
receptacle on the bottom of the trimmer. Plug the adapter into any electrical outlet (at the voltage
listed on the label affixed to the adaptor). The charging indicator will light up to indicate that the
charging has begun. Charging is complete after 4 hours. User will see all 4 bars lit on the trimmer
handle when finished.
3. The adapter may become warm while charging. This is normal.
4. Preserving the battery: In order to maintain the optimum capacity of the rechargeable battery, the
trimmer should be recharged for 4 hours approximately every 6 months.
5. Make sure the switch is in the OFF position (fig. 3) when the trimmer is not operating.
WARNING:
responsible for compliance could void the user's authority to operate the equipment. This device com-
plies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by BaBylissPRO
of this product and the party responsible for compliance, could void the user's authority to operate the
equipment.
FOR DIRECT PLUG-IN OPERATION
Make sure trimmer is off. Connect charging jack into the receptacle at the end of trimmer and plug the
adapter into power outlet.

ON/OFF SWITCH

To operate, simply slide switch up to ON position. To stop operation, set to the OFF position.
VERY IMPORTANT: Blades must be cleaned and oiled on a regular basis for proper
functioning. Failure to regularly clean and oil the blades will void the warranty.
Changes or modifications to this unit not expressly approved by the party
, the manufacturer
®