Setting The Clock - Easy Home R09 Manual De Instrucciones

E
F

Setting the clock

Before you start operating the air conditioner, set the
clock of the remote control using the steps below. The
clock panel on the remote control will display the time
regardless of whether the air conditioner is in use or not.
Initial setting of the clock
After batteries are inserted in the remote control, the
clock panel will display "12:00". Press and hold the
CLOCk button for 3 seconds, the time will begin to flash.
TEMP/TIME adjust button: press this button to set the time.
1.
Forward
Backward
3
Each time you press the button, the time moves forward or backward by one minute,
depending on which button you press. The time alters as quickly as you push the button.
Press and hold the TEMP/TIME button, the time moves forward (or backward) by 10 minute
intervals.
CLOCK button: when the correct time is achieved, press the CLOCK button or release the
2.
FORWARD/BACKWARD button and wait 5 seconds. The clock time will stop flashing and
the clock will start operating.
Readjusting the clock: press the CLOCk button on the remove control for about 3 seconds.
The clock display time will start to flash. To set the new time, follow steps 1 and 2 above.
NOTE: the time of the CLOCk must be set before the AUTO-TIMER feature will operate.
If you readjust the time of the clock after setting the AUTO-ON/OFF timer, the remote control
will send the readjusted timer information to the unit.
Clock accuracy is with 15 seconds per day.
CAUTION: Static electricity or other factors (in case of extremely high voltage)
can cause remote control clock to initialize. If your remote control is initialized
(flashing 12:00), readjust the clock before you start operation.
C LO C K
1
2
Setting the clock
A U T O
FAN SPEED
1
O N
O FF
FAN SPEED
1
2
.
C LO C K SET TEMP .
2
A U T O
C LO C K SET TEMP .
3
22