Publicidad
Idiomas disponibles
Idiomas disponibles
EB 20.book Seite 7 Montag, 16. Februar 2009 2:17 14
GB
Working safely with this machine is pos-
sible only when the operating and safety
information are read completely and the
instructions contained therein are strictly
followed. In addition, the general safety
notes in the enclosed booklet must be ob-
served. Before using for the first time,
ask for a practical demonstration.
The unit must not be damp and must not
be used in a wet environment.
Before each use of the machine, check
the machine, cable and plug. Have re-
pairs carried out only through the Würth
Master-Service or by a qualified techni-
cian. Insert the plug into the socket only
when the machine is switched off.
Always wear protective goggles, protec-
tive gloves and heavy-duty shoes when
working.
For long hair, wear hair protection. Work
only with closely fitting clothes.
Tool Specifications
Sheet Metal Shears
EB 13-2
Order number
0702 713 0
Rated input
300 W
Output
180 W
Stroke rate
3900 min
Maximum workpiece
thickness:
Iron sheet metal
2
(400 N/mm
)
1.3 mm
Stainless steel sheet
metal
(600 N/mm
2
)
1.0 mm
Stainless steel sheet
metal
2
(800 N/mm
)
1.0 mm
Non-ferrous sheet
metal
(250 N/mm
2
)
2.0 mm
Cutting radius
145 mm
(1.3 mm
sheet)
Weight
1.6 kg
Protection rating
/ II
For Your Safety
Do not carry the machine by the cable.
Always remove the plug from the power supply
socket before carrying out any work on the ma-
chine, when interrupting work and when not using
the machine.
Always place the cable to the rear away from the
machine.
Apply the machine to the sheet metal only when
switched on.
Always provide for secure footing when working.
Firmly clamp the workpiece if it does not remain
stationary from its own weight.
The knife should not rub on the jaws: Possible
danger of cutting tool breakage.
Do not exceed the maximum allowable material
thickness especially when cutting over doublers,
folded joints or welded seams.
Use only original Würth parts and accessories.
For further notes on safety refer to the enclosed sheet
Noise/Vibration Information
Measured
EB 20-2
EN 50144.
0702 714 0
Typically the A-weighted sound pressure level of the
500 W
product is 83 dB (A). The noise level when working
300 W
can exceed 83 dB (A). Wear hearing protection!
-1
2200 min
-1
The typical hand-arm vibration is below 2.5 m/s
1 Clamping screw
2.0 mm
2 Drilling for parallel guide
3 Set screw
1.5 mm
4 Fillister head screw
5 Knife
6 Jaws
1.3 mm
7 Washer
8 Knife pin
9 Circlip ring
3.0 mm
10 Spring plate
11 Clamping surface
12 On-Off switch
215 mm
Not all of the accessories illustrated or described are included
1.8 kg
as standard delivery.
/ II
.
values
determined
according
Operating Controls
to
2
.
7
Publicidad
