Publicidad
Idiomas disponibles
Idiomas disponibles
Control the FCOIII's head
Three different solutions to move the head:
A The circle „
B It can be controlled by the optional available FCOIII LinX hand sender (Art.No:
FC3005). Insert the receiver into the RX socket.
C With the optional FCOIII RX cable (Art.No: FC3009).
You need up to three free channels at your R/C receiver for head movement
(Pan/Tilt) and shutter release.
Charging the FCOIII
Charge the camera at your computer's USB-Port (5h) or with the included
adaptor (2h). Charging will be indicated by a pulsing battery symbol
LCD panel. Charging is finished when all elements of the symbol are filled.
Using FCOIII Transmitter Sets (Art.No: FC3002)
Adding the FCOIII Transmitter Set the video signal will be transferred to the
receiver at 2.4GHz up to a range of 300m/980ft. The screen module will be
exchanged against the sender, and the screen will be fixed to the receiver now.
Interferences will not be recorded because the camera will record, not the ground
station.
The FCOIII V-Eyes Video glasses
(Art.No.FC3004)
Instead of the screen, the V-eyes battery pack
will be fixed to the receiver now. See the picture
on two screens in front of your eyes now. The
integrated Head Tracking System combined with
a R/C controller is moving the camera's head
now.
Replacing the LiPo Battery of the FCOIII
Lift the battery and disconnect the plug. Insert the
new one. Dispose empty Batteries at a recycling centre.
Important! Only use the original FCOIII LiPo battery 600mAh with integrated
LiPo-Saver!
ATTENTION!
Through a collision at a high speed, the record can be deleted.
Please note!
The privacy of others is protected by law and should be taboo. The recording of
third party can be an illegal act. You are responsible for your acting.
V.3.03
"of the FCOIII logo controls the head.
www.FlyCamOne.com
in the
Publicidad
