Veranda 34107832BOM Manual Del Usuario página 9

ANGLE BRACKETS
After posts have been installed, determine angle and
1
height of railing (Fig. 1).
Pre-drill ⁄ ⁄ ⁄ ⁄ " diameter holes in base of top bracket only.
1 1 1
8 8
2
Then, fasten bracket to base at the determined angle
with two #10 x 1" square drive screws (Fig. 2).
Cut railing to desired length. Place bracket on each end
3
of top and bottom rails (Fig. 3). Fasten bottom bracket to
base with one #10 x 1" square drive screw.
a. Position the rail section between the posts (Fig. 4).
4
b. Mark four screw hole locations on each bracket. Set
rail section aside, then pre-drill
post at each mark (Fig. 5).
⁄ ⁄ " diameter holes in ⁄ ⁄
1 1 1
8 8
Top View
Determine
Angle
#10 x 1" Screws
Bottom
Rail
Top View
Mark Holes
Mark Holes
Fig. 1
Fig. 2
Fig. 3
Top Rail Top Rail Top Rail
Fig. 4
Fig. 5
9