External Connections - pico Technology PicoScope 6000C Serie Guia De Inicio Rapido

Quick Start Guide
1.2.4

External connections

To prevent injury or death, use only the power cord and adaptor, if any, supplied with the
product. These are approved for the voltage and plug configuration in your country.
Note: Not all oscilloscopes require an external power supply.
USB 2.0
PicoScope models
powered
PicoScope 3000D Series
PicoScope 4224 and 4424 Y
PicoScope 4224 IEPE Y
PicoScope 4262 Y
PicoScope 4824
PicoScope 5000D Series
[1]
PicoScope 6000C/D Series
PicoScope 6407
The external PSU must be connected in order to use more than two analog inputs. Refer to the
[1]
relevant oscilloscope data sheet for further information.
Take care to avoid mechanical stress or tight bend radii for all connected leads, including
all coaxial leads and connectors. Mishandling will cause deformation and will degrade
performance and measurement accuracy.
1.2.5 Environment
To prevent injury or death, do not use in wet or damp conditions or near explosive gas or
vapor.
To prevent damage, always use and store your oscilloscope in appropriate environments.
DO115-20
WARNING
DC power input
USB 3.1
2x USB 2.0
powered
powered
Voltage
Y Y 5 V
Y Y
Y 5 V
12 V
12 V
WARNING
WARNING
CAUTION
Copyright © 2006–2019 Pico Technology Ltd. All rights reserved.
Temperature
Humidity
Altitude
Pollution degree
Some PicoScope models have enhanced environmental specifications. Refer to the
[2]
Current
oscilloscope data sheet for further information.
1.3 A pk
1.2.6 Care of the product
The product contains no user-serviceable parts. Repair, servicing and adjustment require
specialized test equipment and must only be performed by Pico Technology or an approved
service provider. There may be a charge for these services unless covered by the Pico five-year
warranty.
Inspect the instrument and all probes, connectors, cables and accessories before use for signs
of damage.
1.6 A pk
4 A pk
3.5 A pk
To prevent injury or death, do not use the product if it appears to be damaged in any way, and
stop use immediately if you are concerned by any abnormal operations.
To prevent electric shock do not tamper with or disassemble the oscilloscope, case parts,
connectors or accessories.
When cleaning the oscilloscope, use a soft cloth and a solution of mild soap or detergent
in water. To prevent electric shock, do not allow water to enter the casing, as this will
compromise the electronics or insulation inside.
Do not block any of the instrument's air vents (if present) as overheating will cause damage to
the oscilloscope.
Do not insert any objects through the air vents (if present) as internal interference will cause
damage to the oscilloscope.
PicoScope USB Oscilloscopes
Storage Operating
–20 to +60 °C 0 to 40 °C
5 to 95 %RH 5 to 80 %RH
(non-condensing) (non-condensing)
2000 m (maximum)
2 (maximum)
WARNING
CAUTION
Quoted accuracy
20 to 30 °C
[2]
3