Elu MHA24 Manual Del Usuario página 22

E N G L I S H
16 Remove the battery pack
Remove the battery pack when not in use,
before servicing and when changing accessories.
17 Have your tool repaired by an Elu authorized
repair agent.
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Labels on charger and battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
Battery charging
Battery charged
Problem charging
+
Charges NiMH and NiCd battery packs
Do not probe with conductive objects
Do not charge damaged battery packs
Read instruction manual before use
Do not expose to water
Have defective cords replaced
immediately
Charge only between 4 °C and 40 °C
en - 3
See technical data for charging time
Refresh mode
Additional safety rules for circular saws
When sawing
• Remove all nails and metal objects from the
workpiece before starting work.
• Do not attempt to saw extremely small workpieces.
• After switching off, never attempt to stop the saw
blade by pressing against the side of the blade.
• Never put the saw down on a table or work
bench unless switched off.
Operational protection devices
• The circular saw must only be used for cutting
wood or plastic.
• Ensure that all devices screening the saw blade
are in perfect working order.
• Never jam the saw blade guards.
• Free a jammed saw blade guard immediately and
do not use the saw if the guard is jammed.
• Do not remove the riving knife.
• The riving knife should be correctly set;
the distance between the toothed rim and the
riving knife should be max. 5 mm and the height
difference between the riving knife and the
toothed rim should be max. 5 mm.
Checking and changing the saw blade
• Only saw blades conforming to the specifications
contained in these operating instructions may
be used.
• Saw blades made of high alloy, high speed steel
(HSS steel) should not be used.
• Only sharp saw blades in perfect working
condition should be used; cracked or bent saw
blades should be discarded and replaced at once.
• Ensure that the saw blade is securely fixed and
rotates in the correct direction.
Special applications
• When cutting narrow workpieces (width less than
80 mm) longitudinally, use a rip fence guide along
the longitudinal edge.
18