Descargar Imprimir esta página

Bond signature Serie Manual Del Usuario página 11

Ocultar thumbs Ver también para signature Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
HEATING PORTION
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the 'OFF'
position. Brush a soap and water mixture on all connections. Turn the gas supply on. If bubbles
occur on any connection there may be a leak. If you smell gas or a leak is discovered turn the
gas valve off, disconnect propane gas tank and do not use the appliance until the leak is
repaired.
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion
you must replace the hose (if applicable). Pumice stones/lava rocks/LavaGlass
strike somebody's face during the process of lighting this unit. To prevent this, stand away from the
unit for the first 20 minutes after igniting. Flame should be a yellow/blue color between 2 - 10 inches
in height.
Wait 50 minutes after extinguishing flame prior to place a lid (if applicable) or protective cover on
heating item.
To Light
1. Make sure the control knob (K) is in the 'OFF' position.
2. Remove door (F) and slowly open the valve on the propane gas tank by turning the knob
counterclockwise.
3. Replace the door (F) on the body (D).
4. Push and hold in the electronic igniter (L) to create sparks within the electrode, continue to hold.
5. Push in the control knob (K) and turn to the 'LOW' position. Keep holding down the control knob
(K) to allow gas to flow for 15 seconds.
6. If ignition doesn't occur within a few seconds, release the control knob (K) and rotate to the 'OFF'
position. Wait for 5 minutes for gas to clear and then repeat the above lighting instructions.
7. Once the fire product is lit, the flame intensity may be controlled by turning the control knob (K)
between the 'LOW' and 'HIGH' positions.
To Extinguish
1. Turn control knob (K) clockwise to the 'LOW' position; let the knob pop up and continue turning
the control knob (K) to the 'OFF' position.
2. Close the cylinder valve on the propane gas tank if you don't intend to use it for a long time.
FOUNTAIN PORTION
While fountain is designed to operate as splash free as possible, some water splashing out of the
fountain is inevitable. Place the fountain in a location where any splashing will not cause damage.
functioning of the pump.
ALWAYS MAKE SURE THE PUMP IS FULLY SUBMERGED UNDER THE WATERLINE PRIOR TO
TURNING PUMP ON.
could pop up and
®
1-866-771-2663 | Page 11

Publicidad

loading

Este manual también es adecuado para:

Signature bff3001-1Y95849