Publicidad
Idiomas disponibles
Idiomas disponibles
TURN ON
Plug in the power plug to turn on the power; this will start the fountain's water pump.
TURN OFF
Unplug the power plug or turn off the power, the pump will turn off and stop work.
NOTE:
1. Drain the water if you don't plan to use the fountain for a long time to prevent mosquito
breeding and water odor.
2. Be sure to drain all water during winter months or cold seasons to prevent reservoir from
cracking or breaking.
3. See the instructions below for draining the water in reservoir.
1. Unplug the power plug, remove the
1. Unplug the power plug, remove the
decorative ring (A) .
decorative ring (A) .
WARNING
Risk of electric shock. Install only to a
covered class A GFCI receptacle that has
an enclosure that is weatherproof with the
attachment plug cap inserted or removed.
Risk of electric shock. Mount the unit at a
height greater than 0.3 m from the ground
surface.
Bond Manufacturing Co., Inc. | Page 12
A
2. Submerge the drain hose (Q) completely in
the reservoir, fully fill the hose with water and
seal the two ends with two thumbs or fingers.
Then put one end of the hose into the reservoir
and the other end outside the body, make sure
the outside end is lower than bottom of the
reservoir. Remove the two sealing thumbs or
fingers at the same time, the water will flow out
through the drain hose.
Q
WARNING: Please check and
ensure the power cord is not dam-
aged before using this appliance.
Publicidad
