Bond signature Serie Manual Del Usuario página 16

C C C A A A U U U T T T I I I O O O N N N
Always disconnect from electrical outlet before handling the pump.
Don't operate without water.
Do not lift the pump by the power cord.
For liquids having a temperature not exceeding 50
Operate in freshwater only.
Operate pump completely submerged for proper cooling.
Not for swimming pool.
This pump has been evaluated for use with water only.
P P P E E E R R R F F F O O O R R R M M M A A A N N N C C C E E E
A clogged or dirty intake screen will greatly reduce performance.
Do not let the pump run when not submerged in water. Doing so may damage the pump. Always
submerge the pump in the water before plugging in the electrical outlet. It is common for air to be
in the pump and tube when first plugged in. Continue to unplug the electrical cord and then plug
it back in until water begins to flow.
NOTE: Ensure that the electrical cord loops below the electrical outlet to form a 'Drip Loop'.
This will prevent water from running down the cord into the electrical outlet.
M M M A A A I I I N N N T T T E E E N N N A A A N N N C C C E E E
NOTE: Always disconnect from electrical outlet before handling the pump.
To clean the pump, remove the back cover and the impeller.
Use a small brush or stream of water to remove any debris
IF THE PUMP FAILS TO OPERATE, CHECK THE FOLLOWING:
Check the circuit breaker and try another outlet to ensure the pump is getting electrical
power.
Check the pump discharge and tubing for kinks and obstructions. Algae build up can be
flushed out with a garden hose.
Check the inlet to ensure it is not clogged with debris.
Remove the pump inlet to access the impeller area. Turn the rotor to ensure it is not
broken or jammed.
Monthly maintenance will add to your pump's life.
Bond Manufacturing Co., Inc. | Page 16
℃ (122°F).