Assembly; Removal Of Shipping Protection; Leg Installation; Mounting The Infeed Table - Metabo HC 260 C Manual Original

ENGLISH
en
• Per pass a maximum of 3 mm mate-
rial can be removed.
40
39
Fence profile
The fence profile (41) provides lateral
support for the work piece when surface
planing.
• After loosing the clamping lever (43)
the fence profile can be adjusted to
the width of the work piece.
• Loosen the lock lever (42) to tilt the
fence extrusion to a maximum of
45°.
41 42

5. Assembly

A
Danger!
Modification of the machine or use of
parts not tested and approved by the
manufacturer can cause unforeseen
damage.
• Assemble machine exactly as per
these instructions.
• Use only the parts supplied with
the machine as standard equip-
ment.
• Do not change any parts.
Required tools
 Spanner 10 mm
 Spanner 13 mm
 Philips screwdriver
 Angle for 45° and 90°
 Allen key (different sizes)
5.1 Removal of shipping pro-
tection
• Remove foil protection from the
thicknesser bed.
20
5.2

Leg installation

1. With the help of a second person
turn the machine upside down and
place it on a suitable support.
44
43
2. Fasten the four legs (44) to the
inside of all corners of the machine:
 Fit hexagon head screws (48)
into holes from the outside;
 place washers (47) and
 hexagon nuts (46) on screws and
tighten.
3. Slide rubber feet (45) on legs.
49
4. Mount both transport wheels (49) to
the legs on the side of the outfeed
table with hexagon head screws,
washers and hexagon nuts.
5.3

Mounting the infeed table

45
46
47
48
5.4 Mounting the thicknesser
bed height adjuster
5.5

Chip chute installation

50
52
53
• Attach chip chute (50) with four self-
tapping screws (51) to the mounting
profile (52).
• Attach adjusting screw holder (54)
with two self-tapping screws (53) to
the mounting profile (52).
51
54