Safety Devices; Safety Information - Bartscher AB12/T Manual De Uso Y Mantenimiento

Tabla de contenido

Publicidad

Safety devices

Microswitch:
stops
the
when the grater lever is lifted. When
the lever is lowered, restart the
machine by pressing the I button.

Safety information

It is of the greatest importance to carefully read this manual before carrying out installation and use
operations. Consistent compliance with the instructions contained in this manual will guarantee personal
and machine safety.
Do not tamper with the safety devices for any reason.
We recommend that industrial safety regulations issued nationally by the appointed organisms be strictly
respected.
The manufacturer declines all responsability for injures to persons or damages to property, resulting from
failure to comply with these safety rules.
Correct machine setting, lighting and workshop cleanness are pre-conditions for personal safety.
Do not expose the machine to atmospheric agents.
The machine connection and start-up should only be executed by skilled engineers.
Check that the plant mains ratings correspond to the specifications printed on the machine data plate.
Make sure that the machine is connected to a grounding system.
The work area around the machine should always be kept clean and dry.
Wear the work attire prescribed by the industrial accident-prevention regulations.
This machine should always be used for its recommended uses ; any other use is deemed improper and
therefore dangerous.
Check the suitability and weight of the products to work ; do not overload the machine to exceed its
capacity.
It is forbidden to introduce any objects, tools or hands in the dangerous parts.
Keep the machine out of children' s reach.
Unplug the machine from the mains when not in use.
In the event of breakdowns and/or malfunctioning, do not carry out any repair yourselves, apply to your
Authorised dealer.
Order original spare parts only.
Before carrying out machine cleaning, unplug it from the power mains.
Do not clean with high-pressure water jets.
Should wear cause plate thickness to drop under 5 mm, we recommend
you replace it. The manufacturer is not liable for any personal or property
machine
DANGER – CAUTION: Using plates with hole diameters over 8mm
and with total thickness under 5 mm is strictly prohibited.
damages due to failure to observe these instructions.
INFORMATION
Remote control switch: can be used
to restart the machine when the
electricity
accidentally.
For Grater mod.GR12/S only, when
the machine stops, the electronic board
intervenes to block the roller using the
motor brake.
7
1
GENERAL
supply
is
switched
off

Publicidad

Tabla de contenido
loading

Tabla de contenido