Controls & Features; Controls & Operation - Troy-Bilt TB 672 Manual Del Operador

Controls & Features
Blower Housing
Controls
WARNING! Read and follow all safety
rules and instructions in this manual
before attempting to operate this
machine. Failure to comply with all
safety rules and instructions may result
in personal injury.
Engine
Refer to the Engine Operator's Manual for details
regarding all engine-related controls and features.
Discharge Chute
The discharge chute is located on the left side
of the jet sweep and directs the air flow.
Blower Direction Lever
The air flow can be directed to one of three
directions using the blower direction lever to
reposition the louvers. See Figure 4-2.
WARNING! Do not stand in front of
discharge area.
BLOWER DIRECTION LEVER
Figure 4-2
6
Engine
Blower Direction Lever
Discharge Chute
Figure 4-1
Operation
Starting & Stopping the Engine
Refer to the Engine Operator's Manual for
instructions on starting and stopping the engine.
Adjusting the Blower Direction
The air flow can be directed to one of three
directions using the blower direction lever to
move the louvers.
WARNING!
operating blower. Do not allow the
directional discharge chute to point in
the direction of bystanders or pets.
NOTE: The blower direction lever must be in the
middle position when operating the blower with
the chute attachment to keep it locked in place.
1. Pull the lever out and away from the
blower. See Figure 4-3.
2
Exercise caution when
1
Blower Direction
Lever
Louvers
Side view
Figure 4-3
2. Move the lever to the left to direct airflow
downward or to the right to direct airflow
upward. See side view in Figure 4-3.
3. Release lever towards blower, making sure it
secures into place.
Attaching the Chute Attachment
WARNING!
DO NOT operate
without shields and guards in place.
To redirect airflow at a 90° angle during operation,
a chute attachment is included with your jet sweep
blower.
1. Pivot the blower direction lever all the way to
the right, into the highest position. See Figure
4-4.
2
1
Figure 4-4
2. Slide the chute attachment downward,
over the opening.
3. Pivot the direction lever to the middle
position to lock the chute attachment in
place. See Figure 4-4.
WARNING!
Keep hands out of inlet
and discharge openings while
machine is running. There are
rotating blades inside.
4
3