Keypad; Operation; Application Of The Detector - Instrumax REDLINER 2V Manual Del Usuario

4
1. Adjusting legs
2. Fine adjustment screw
3. Switch On handle (compensator lock)
4. Horizontal laser window

5. Keypad

6. Vertical laser window
7. Battery compartment
8. Hole for charger connection
9. Thread 5/8'' / Plumb down
3
Keypad
1. On/Off button / Detector mode
2. Button to switch Vertical laser
3. Button to switch Horizontal laser

Operation

1. Place the instrument on the tripod or floor. When using tri-
pod, place the instrument on the tripod and screw the center-
ing screw into the center hole.
2. Move the switch (3) clockwise.
3. If there is a sound signal and laser lines begin to blink while
switching on the instrument, that means that the instrument is
out of range more than ±3°. Adjust the position of the instru-
ment by means of the bubble level with the help of legs or
tripod.
4. Press button H (3) to switch ON/Off horizontal line. Press
every time button V (1) to switch On/Off vertical lines. Press
button 1 every time to select beams. Variants of projections:
-vertical beam, down point
- two vertical beams, down point
5. Aim the down point on the required point on the floor. Ro-
tate the upper part of the instrument to adjust vertical lines.
Then adjust the position of the instrument with the help of fine
adjustment screw.
6. During transportation move the switch (4) into position
OFF. Place the instrument into the soft bag or case. Do not
drop the instrument during transportation.

Application of the detector

Use detectore mode when operating in bright sunlight. Press
button (2) to activate this mode. Indicator (4) lights up. Place
the detector to the approximate location of the beam. Follow