Aqua Medic Refill System pro Manual De Instrucciones página 6

The level control Refill System pro is an automatic top up unit for a cabinet filter.
1. Delivery
1. Power supply AC/DC, Input 100 - 240 V AC 50/60 Hz, Output 12 V DC 1.0 A
2. Control unit
3. Infrared sensor N1
4. Sensor N2
5. Refill pump Input DC 3.5 - 12 V DC / 0.5 – 5.0 W H
6. Sensor N3
7. 2 m refill hose 8/12
2. Features
- Permanent monitoring of the water level in the aquarium with an infrared sensor incl. delay circuit.
- Automatic refilling of evaporated aquarium water.
- Adjustable water level with overflow protection in the filter tank (safety shutdown in case of a defective level
sensor).
- Dry-running protection of the refill pump – optical and acoustic alarm.
- Easy installation and maintenance due to plug connections on all cables.
- 12 V low voltage
3. Safety instructions
- When working in the aquarium, always disconnect all units from the power supply system before putting
your hands into the water. Connect all units to the mains via a residual current device with a maximum
residual current of 30 mA.
- Suitable for indoor use only.
- Protect the power supply and controller from moisture, splash and condensate.
- Not suitable as a toy for children.
4. Installation
Important! Please turn on the power supply only when all of the cables and sensors are connected,
otherwise the control unit may be damaged. Unplug the power from the unit in case plugs are to be
pulled.
The Aqua Medic Refill System pro is designed as a refill unit for cabinet filter systems, only if the aquarium has
a minimum height of approx. 13 cm between the top of the aquarium and the water level. Mounting of the
sensors N1 and N2 is achieved with the bracket supplied.
Pict. 1: Socket of the control unit
LED display:
D1 = Refilling is active
D2 = Alarm in case of low water level in the refill unit (+ beep)
D3 = Power
6
Operation Manual ENG
= 220 cm Q
max
= 350 l/h
max