Install The Hardware; Attaching Antennas - Zyxel NWA-3100 Guia De Inicio Rapido

Idiomas disponibles

10 Change the wireless settings in the wireless stations to match those of the NWA-

3100. Refer to your wireless adapter's documentation.

If you change the NWA-3100's IP address, you must use the new IP

address when you next access the web configurator.

The device is now ready to connect to your wired network. You can do this now, or once

you have installed the hardware.

If the wireless clients cannot access the wired network, verify that the IP

address and the subnet mask of the NWA-3100 and the computers on the

network are in the same range. If the ETHN LED is off, check the cables

between the NWA-3100 and your computer or hub.

4 Install the Hardware

When facing the front of the NWA-3100, the right antenna (main antenna)

transmits and receives; the left antenna only receives.

1 Screw the antennas clockwise onto the

antenna connectors on the sides of your

NWA-3100. The antennas should be

perpendicular to the ground and parallel

to each other.

Make sure the antennas are securely

screwed onto the antenna connectors.

ENGLISH

Tabla de Contenido