Chicco Essential Digital Audio Baby Monitor 06607 Instrucciones De Uso página 20

the power cord or plastic parts show signs of
damage, do not use them and contact a qualified
technician.
- Do not leave mains adapters (1) plugged into
the outlet when devices are not in use and/or not
connected to the mains adapters (1).
2.1.2 Modes of use - Switching on and
Adjustment
The child unit (primarily in transmitter mode)
must be positioned about 1 - 1.5 metres from
the child, on a flat, stable surface and with the
microphone (7) directed toward the child.
Attention: the transmitter, mains adapter and its
power cord must be kept out of reach of children.
• Child unit (primarily in transmitter mode) On/
Off button (2).
Press this button for about 3 seconds and the
child unit will switch on. Do not press for too long,
otherwise the child unit may not switch on. Press
this button (2) again for about 3 seconds and the
child unit will switch off.
• Night light On/Off button (4)
Press this button for about 3 seconds and
the nightlight (3) will switch on steady and at
minimum intensity.
Do not press for too long, otherwise the nightlight
(3) may not switch on.
If during this operating mode, you press the
nightlight On/Off button (4) once, the "Variable
brightness nightlight" mode will be activated.
Brightness will automatically vary from maximum
level to minimum level.
At the twelfth minute, nightlight brightness will
remain fixed at minimum level.
During the "Variable brightness nightlight"
operating mode, if the nightlight On/Off button
(4) is pressed once, light brightness will return
steady at minimum level.
If the nightlight On/Off button (4) is pressed
again in this operating mode, the brightness
variation cycle will begin again, starting from
maximum level.
Press the nightlight On/Off button (4) button
again for 3 seconds and the nightlight will switch
off, both in minimum, steady brightness and in
"Variable brightness nightlight" mode.
For energy savings, when the child unit (primarily
in transmitter mode) is being powered via Alkaline
batteries, the nightlight, if in minimum intensity
and steady mode, switches off automatically 5
minutes after the end of the 'Variable brightness
nightlight" operating mode cycle.
If the child unit (primarily in transmitter mode)
is being powered via mains adapter (1), the
nightlight will remain on in both modes until the
button (4) is pressed again for 3 seconds.
The nightlight can be switched on even when the
child unit is off.
2.1.3 Operating indicator lights
- The power and link indicator light (5) supplies 3
different pieces of information:
- Indication that the device is on and properly
connected to parent unit:
the indicator light (5) will light up steady green.
- Indication of loss or absence of link with the
parent unit during operation:
the indicator light (5) will light up green and
begin to flash.
As soon as the link with the parent unit is restored,
the indicator light (5) will light up steady green.
NOTE: when the child unit switches on, it
searches for the channel to link with the parent
unit; therefore the indicator light (5) will flash
green until a link is established.
-Indication of device off:
the indicator light (5) will switch off.
- The Alkaline battery status indicator light (6)
supplies 2 different pieces of information:
-Indication that Alkaline batteries are almost flat:
the indicator light (6) will light up red and begin
to flash.
- Alkaline batteries charged or operation via
mains adapter (1):
the indicator light (6) will switch off.
2.2 Parent unit (primarily in receiver mode)
2.2.1 Power:
Power via supplied rechargeable 3.7V 800mAh
lithium-ion battery (13) or via 100-240V ~
50/60Hz /6V
ATTENTION. The charging of rechargeable
batteries should only be done via the supplied
mains adapter (1) and can be performed both if
the parent unit is switched on and if the parent
unit is off.
In the event of power with mains adapter (1) or
rechargeable lithium-ion battery charging:
- insert the mains adapter jack (1) in the power
connector (12) on the side of the unit.
- verify that the voltage corresponds to the rating
20
500mA (1) mains adapter
plat
- in
acce
Wa
- Th
of s
- P
the
dam
tech
- D
the
con
2.2.
Adj
• Pa
Off
Pres
pare
long
on.
and
A b
unit
• Lo
- (3
Pres
sym
leve
the
leve
defa
A be
or d
max
will
The
dur
has
• V
ON
The
tran
or
pos
unit
of a
belo
thre
are