LauraStar SMART I Manual De Instrucciones página 7

Fabric type
Inside and
Blower Back Darts linings,
sleeves
Buttons Turn-ups Buttons and
Vacuum
and collar and pleats collars
become shiny, for delicate fabric like silk and synthetic fabrics which have a
E
tendency to stick to the iron.
Using the protective soleplate (27) :
• First place the tip of the iron (2) at the front of the protective soleplate
(27) and lower the iron to fix it in place in the soleplate.
• Wait approximately 2 minutes for the soleplate to reach the correct
temperature.
To remove the protective soleplate, pull on the tab and remove the iron while
F
it is still hot.
F
WARNING: The protective soleplate is hot! Use caution when you
remove the protective soleplate.
NOTICE: ALWAYS remove the protective soleplate after use.
Advice: For mohair, cashmere, velvet and angora: do not allow the fabric
to come into contact with the protective soleplate (27). Iron the fabric at
a distance of approximately 10 cm (4 in) while diffusing steam, so that the
G
fabric does not become felted.
and shake it to restore its volume.
For velvet, corduroy and jersey, we recommend steaming without the
protective soleplate (27) at around 2-3 cm (1-2 in) from the fabric, then
levelling out by hand.
Velvet
Top and
ü ü
pleats
ü
Pleats
E
Then take the item of clothing in your hand
G
- 11 -
H
ü
B
Vertical smoothing out
Suspend the item of clothing on a hanger or on the vertical support bracket
(available on www.laurastar.com or at your approved Laurastar retailer).
Moving the iron from top to bottom, lightly touch the fabric using short bursts
of steam. Note: almost all fabrics smooth out easily, with the exception of
cotton, linen and certain silks. H
If a fabric is difficult to smooth out, place it on the ironing board and iron it
normally.
WARNING: Do not iron or vertical steam clothes that are
being worn. Do not point vertical steam in the direction of
people or pets.
A
Filling
Empty water indicator light (20) and warning tone
A warning tone sounds and the empty water indicator light (20) flashes to
signal that there is no water left in the steam generator's reservoir.
As soon as the warning tone sounds, the steam stops and you must refill the
water reservoir (11).
How to fill the water reservoir (11)
• Remove the water reservoir (11) from its place. Take off the reservoir lids.
• Fill the reservoir with tap water. The filtered water must reach the MAX
level.
• Close the lids and put the reservoir back in its place on top of the steam
generator (15).
B
- 12 -
EN
A