Mounting Steps - Kingstone 23674305 Manual De Instrucciones

Box wrench 8 mm or Pliers and a suitable screwdriver.

Mounting steps:

To ensure the successful assembling, pls do not tighten up the
screws until all the parts fixed in the correct way.
1. The connection of ash holder(L) and the bottom of firebowl,The
header of ash catch holder(J) insert into the bottom sleeve tube of
the firebowl. The grey handle insert into the gap of ash catch
holder(J);Fix the handle (K) and plate(G),ash holder(L),Then
fasten the ash catcher(L) on the ash catch holder(J),And then to
turn the fire bowl upside down, and insert the end of the long leg
(O) into the sleeve tube on the bottom of the firebowl. Pls take the
note that the long tube leg must be assembled in line with the
handle position on the firebowl, so that you can pull the grill with
the wheels after assembled.
2. In the same way as above to fix the two wheel legs (N) , but to
make sure that the two wheel legs will be assembled onto the two
sides of the other firebowl handle.
3. To assemble the bottom wire shelf onto the tube legs, and to
put the wheels ( Q ) on, then to tighten the screws.
4. To put into the firebowl, the charcoal grid ( F ), cooking grill ( E )
one after another. The charcoal grid is smaller, so it is put inside
first, then the cooking grid which is bigger. Then to assemble the
temperature gauge ( B ) on the corresponding mounting holes on
one side of the lid top, and to fix the air vent ( C ) onto the other
mounting hole.
5. Tighten up all the screws/nuts so as to complete the
assembling.
8