Proxxon MICROMOT 60 Manual De Instrucciones página 16

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 39
arm may be pulled into the spinning acces-
sory.
o) never lay the power tool down until the
accessory has come to a complete stop.
The spinning accessory may grab the sur-
face and pull the power tool out of your con-
trol.
p) after changing the bits or making any
adjustments, make sure the collet nut,
chuck or any other adjustment devices
are securely tightened. Loose adjustment
devices can unexpectedly shift, causing
loss of control, loose rotating components
will be violently thrown.
q) Do not run the power tool while carrying
it at your side. Accidental contact with the
spinning accessory could snag your cloth-
ing, pulling the accessory into your body.
r) regularly clean the power tool's air
vents. The motor's fan will draw the dust in-
side the housing and excessive accumula-
tion of powdered metal may cause electrical
hazards.
s) Do not operate the power tool near flam-
mable materials. Sparks could ignite these
materials.
t) Do not use accessories that require liq-
uid coolants. Using water or other liquid
coolants may result in electrocution or
shock.
Further safety instructions for all op-
erations
Kickback and related warnings
Kickback is a sudden reaction to a pinched or
snagged rotating wheel, sanding band, brush
or any other accessory. Pinching or snagging
causes rapid stalling of the rotating accessory
which in turn causes the uncontrolled power
tool to be forced in the direction opposite of the
accessory's rotation.
- 16 -
For example, if an abrasive wheel is snagged
or pinched by the workpiece, the edge of the
wheel that is entering into the pinch point can
dig into the surface of the material causing the
wheel to climb out or kick out. The wheel may
either jump toward or away from the operator,
depending on direction of the wheel's move-
ment at the point of pinching. Abrasive wheels
may also break under these conditions.
Kickback is the result of power tool misuse
and/or incorrect operating procedures or con-
ditions and can be avoided by taking proper
precautions as given below.
a) Maintain a firm grip on the power tool
and position your body and arm to allow
you to resist kickback forces. The opera-
tor can control kickback forces, if proper
precautions are taken.
b) use special care when working corners,
sharp edges etc. avoid bouncing and
snagging the accessory. Corners, sharp
edges or bouncing have a tendency to snag
the rotating accessory and cause loss of
control or kickback.
c) Do not attach a toothed saw blade. Such
blades create frequent kickback and loss of
control.
d) always feed the bit into the material in
the same direction as the cutting edge
is exiting from the material (which is the
same direction as the chips are thrown).
Feeding the tool in the wrong direction
causes the cutting edge of the bit to climb
out of the work and pull the tool in the direc-
tion of this feed.
e) When using rotary files, cut-off wheels,
high-speed cutters or tungsten carbide
cutters, always have the work securely
clamped. These wheels will grab if they be-
come slightly canted in the groove, and can
kickback. When a cut-off wheel grabs, the
wheel itself usually breaks. When a rotary
file, high-speed cutter or tungsten carbide
cutter grabs, it may jump from the groove
and you could lose control of the tool.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Micromot 60 eMicromot 60 ef

Tabla de contenido