Technical Specifications - Vetus RCM2 Manual De Manejo Y Instrucciones De Instalación

5 How to add and program
additional transmitters
Each new transmitter must be added. A maxi-
mum of 5 transmitters can be coupled to one
receiver. If a 6 th transmitter is added the 1
transmitter will be deleted from the memory of
the receiver.
Procedure to add a new transmitter to the re-
ceiver:
1. Make sure that the wiring for the receiver is
connected to the power supply but do not
switch this on yet.
2. Switch on the new transmitter. Hold the 'ON'
button on the transmitter pressed in for 2
seconds.
3. Turn on the power to the receiver.
Note! After the power has been switched on,
the new transmitter can only be added dur-
ing the 15 seconds that the red LED is on!
4. Press and hold in the appropriate button on
the new transmitter.
6

Technical specifications

Remote control
Power supply
Protection class
Frequency
Temperature range
Weight
Receiver
Power supply
Protection class
Frequency
Temperature range
Weight
Maximum current (per output) : 3 A (at max. 30 Volts DC)
vetus® Radio Remote Control
5. Now also press the button 'PROG' on the re-
ceiver. Both buttons can then be released.
The red LED will now flash 4 times and then
go out. This confirms that the transmitter
has been added correctly.
st
6. Check that the new transmitter works cor-
rectly.
: 2 batteries 1.5V AAA
: IP66
: 433.92 Hz
: 0 - +70°C (+32 - +158°F)
: 85 g (3 oz)
: 10 to 30V DC
: IP65
: 433.92 Hz
: 0 - +70°C (+32 - +158°F)
: 100 g (3.5 oz)
ENGLISH
PROG.
RCMRX4
433.92 MHz
PROG.
5
060216.01