How To Install - Overmax Multipic 2.5 Manual Del Usuario

Remote control (fig. 2)
1.
On/off key
2.
Display proportions select key
3.
Direction keys
4.
EN Homepage
5.
Menu
6.
Volume down
7.
Settings

How to install

Standard settings
See the table below to adjust the size of picture and projector distance.
•
When installing, place the projector on a stable surface or suspend under
ceiling. Do not cover or block air holes.
•
If the distance between the projector and screen is lower than the
minimum or is too large, the picture may be blurred.
How to use the device
Switching on and off
•
When the projector is connected to the source of power, it switches into
standby mode. The control light glows in red.
•
To switch the projector or or off, press the on/off key at the top of the
housing or press on/off key on the remote control. The projector is ready
for operation when the control light turns blue.
Ratio
Picture size (inches)
50
70
100
120
8.
Rotate screen
9.
Select source
10. Confirm
11.
Return key
12.
Volume up
13.
Mute
16:9
Distance (m)
1.55
2.17
3.10
3.72