Calorie Consumption; Memory Mode - CICLOSPORT CICLOPULS CP 16is Manual Del Usuario

To start the stopwatch, select the stopwatch function by
pressing the Mode button and then press the Set button
(the memory function will be started at the same time).
Press the Set button again (in stopwatch mode) to stop the
stopwatch (and also the memory function).
The times recorded within the set limits may be recovered
in the Memory mode (ref. subsection 5.4) by repeatedly
pressing the Set button.
To reset the stopwatch to zero (and, at the same time, the
training times, average and maximum heart rates and
calorie consumption), press and hold the Set button for
3 seconds in the stopwatch mode.
Warning: this will also cancel the stored values.
Whilst the values are being recorded, it is always
possible to recall another function without stopping
the stopwatch.
The stopwatch works up to a maximum value of 23:59:59
hours. When this value is reached the stopwatch will stop.
32
CP16iS_engl.indd 12

5.3 Calorie consumption

The calories consumed are only calculated if the memory
function has been switched on (ref. subsection 5.2).
The value is shown in kilocalories.
The display changes automatically between the actual
calorie consumption ( C ) and the total calories ( T ).
The stopwatch must be reset to zero to reset the calorie
consumption to zero.

5.4 Memory Mode

Press the Set button several times
to recover the values stored. The
current heart rate is always shown
at the same time in the lower part of
the display.
10.04.12 14:22