DynaTrap DT1750 Manual Del Propietário

DT1750
OWNER'S MANUAL
Thank you for purchasing
the DYNATRAP Insect Trap!
®
This product may be covered by one or more U.S. patents
or pending patent applications. See www.DynaTrap.com/patents
IMPORTANT: READ CAREFULLY
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
WARNING:
when using electric appliances, basic precautions should
always be followed, including the following:
1. Please read all instructions before using the DynaTrap Insect Trap and keep for future reference.
®
2. To disconnect, turn all controls to the off ("O") position, then remove plug from outlet.
3. To reduce the risk of injury from moving parts or electric shock, always turn unit off and disconnect plug before
servicing or cleaning.
4. Always unplug before replacing lamp. Replace with same type rated 26-Watt bulb, DynaTrap
5. Do not position the unit near heat, gas, oil or other flammable materials.
6. Place out of reach from children.
7. To reduce the risk of electrical shock, do not put appliance in water or other liquid.
8. Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or if it has been dropped into water or other liquid.
9. Connect only to a circuit that is protected by a ground-fault circuit-interrupter (GFCI).
10. Do not insert fingers or any foreign objects into the unit while it is connected to an electrical outlet.
11. Collected insects within the unit may contribute to fire, so clean insects from the unit frequently.
12. Do not clean this product with water spray. Do not place where it can fall into water, or near flammable materials.
13. Do not touch fan while in motion.
14. Do not abuse cord—never carry or hang unit by cord or yank it to disconnect from receptacle.
Keep cord away from sharp edges.
15. If using outdoors, use only extension cords with a tag stating, "Suitable for Use with Outdoor Appliances."
16. Use only extension cords that have plug and receptacles that match the product plug. Replace or repair damaged cords.
17. Only use attachments recommended or sold by the manufacturer.
18. This appliance is provided with double insulation. Use only identical replacement parts.
See instructions for Servicing of Double-Insulated Appliances.
INSTALLATION & OPERATING INSTRUCTIONS
1. Unpack unit. Save carton for off-season storage (if needed).
2. If hanging the unit, place approximately 3-6 feet above the floor/ground level for optimal catch rate and easy
access for cleaning. Unit can also be placed on the floor or ground.
3. Plug cord into an outdoor outlet or extension cord as described in "IMPORTANT SAFETY INSTRUCTIONS".
4. Turn power switch to "ON" postion. The switch is located under the upper housing on the outer rim.
5. For best catch results leave unit on at all times, except when cleaning or servicing.
6. Catch rate activity will be higher at night. For best catch results it is recommended to keep the unit away from
competing light sources.
7. It is recommended to place the unit at least 20 to 40 feet away from your outdoor living area.
8. This unit is all-weather resistant - designed for outdoor use including rainy conditions. Intended for household use only.
9. To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This
plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
10. SERVICING OF DOUBLE-INSULATED APPLIANCES - In a double-insulated appliance, two systems of insulation are
provided instead of grounding. No grounding means is provided on a double-insulated appliance, nor should a means
for grounding be added to the appliance. Servicing of a double-insulated appliance requires extreme care and
knowledge of the system and should be done only by qualified service personnel. Replacement parts for a double-
insulated appliance must be identical to those parts in the appliance. The symbol must be identical to those parts in
the appliance. A double-insulated appliance is marked with the words "DOUBLE INSULATION", "DOUBLE-INSULATED"
or the symbol:
FCC COMPLIANCE
This device complies with part 18 of the FCC rules. This product may cause interference to radio equipment and should not
be installed near maritime safety communications equipment or other critical navigation or communication equipment
operating between 0.45-30 MHz. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
USER MAINTENANCE INSTRUCTIONS - CLEANING
Frequent cleaning will prolong the life of the unit, ensure fire prevention and provide for more efficient operation.
1. Be sure to clean the unit once per week
2. Switch the unit off and unplug before cleaning
3. Twist the cage clockwise. Remove any buildup from the inside of the retaining cage.
4. Clean before off-season storage.
IMPORTANT: When replacing the retaining cage – DO NOT press/push against the screen windows.
REPLACING BULB Replace With DynaTrap Bulb #43050 (or equivalent G24 Type - 120V/26W Bulb)
The light bulb life expectancy is approximately 3,000 hours (or about 4 months), and should be replaced regularly to
ensure optimal UV effectiveness. Even though the bulb's light may be visible to you, its ability to attract insects diminishes
over time.
1. Turn power switch to "off" position. UNPLUG UNIT, and allow bulb to cool before replacing.
® model 43050.
Turn the unit upside down.
2. Twist the black threaded fastener piece securing the light housing counter clockwise to loosen. Move the light
housing to the side.
3. Twist the two black threaded fastener pieces securing the light and carefully remove the silver clips.
4. Cover the bulb with a cloth to protect your fingers and hand. Grasp the bulb (with your hand and fingers protected
by the cloth) and gently pull the bulb from the socket.
5. Remove any debris from the lamp socket with a brush before inserting the new bulb. Insert new replacement bulb.
Place metal clips in place and secure black threaded fasteners.
6. Twist the light housing clockwise into place and secure the black threaded fastener.
HOW THE DYNATRAP INSEC TRAP WORKS
®
Flying insects are attracted to the unit by the UV
light and CO2 that is generated by the photo-
catalysis between the UV lamps and the special
TiO2 coating. The fan then pulls the insects into the
screened base, trapping them until they dehydrate
and die. The base can be removed, allowing the
contents to be periodically emptied into the trash.
Monitor the insects trapped in the retaining cage,
through the see-through screen, and empty when
compartment becomes full.
HANGER
ON/OFF
UV BULB
SWITCH
TiO COATED
2
SURFACE
LIGHT
ENHANCING
FAN
DIFFUSER
RETAINING
FUNNEL
CAGE
TROUBLESHOOTING
Problem: Possible cause: Correction:
Bulb does not illuminate No electrical power. 1. Check plug, receptacle, and fuse or circuit breaker.
and fan does not spin.
Bulb illuminates, but fan Shorted fan. 1. UNPLUG UNIT: Examine fan to see that it is free from foreign material,
does not spin. dirt or buildup of dead insects.
2. Clean unit as in "CLEANING" section.
Fan spins, but bulb does not 1. Bulb not seated 1. Check bulb socket for any debris and remove, if necessary. Align base
illuminate. properly of bulb with socket and press firmly until it is fully seated to ensure
electrical contact. Bulb is fully seated when it can no longer move in the
socket. Ensure metal bulb holder is replaced and securely fastened, so
the bulb cannot move.
2. Burnt out bulb 2. Replace bulb if needed following instructions under "Replacing Bulb"
If problems persist, please contact DynaTrap
1-877-403-8727 (TRAP) or dynatrap@woodstream.freshdesk.com.
LIMITED WARRANTY
DYNAMIC warranties to the original purchaser that this product is free from defective materials and workmanship.
This warranty is limited to remedy any defective part for a period of one year from date of original date of purchase.
Retain your original receipt as proof of purchase. This warranty does not apply to the light bulb, nor to, in our
judgment, misuse or abuse. If this unit has been altered, no warranty is in force. This warranty does not apply if this
unit is purchased outside the United States, excluding Canada and Mexico. In no case shall DYNAMIC be liable for
any accidental, punitive, consequential, or any other damages of any kind for breach of this or any other warranty,
expressed or implied, whatsoever. Some states do not allow limitation on how long an implied warranty lasts, so the
above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also
have other rights that vary from state to state.
REPLACEMENT PARTS
43050 26-Watt UV Replacement Bulb (1 piece)
To see all replacement and accessory parts available for your DynaTrap visit www.DynaTrap.com.
SAVE THESE INSTRUCTIONS
GANCHO
INTERRUPTOR PARA
PARA COLGAR
PRENDER O
FOCO
APAGAR
ULTRAVIOLETA
SUPERFICIE CON
CAPA DE TiO2
FOR HOUSEHOLD USE ONLY
LUZ
MEJORANDO
Dynamic Solutions Worldwide, LLC
VENTILADOR
DIFUSOR
69 N. Locust St., Lititz, PA 17543
1-877-403-8727 (TRAP)
dynatrap@woodstream.freshdesk.com
www.dynatrap.com
CAMARA DE
EMBUDO
RECOLECCION
This device complies with Performance Standards
for Light-Emitting Products, 21 CFR, Part 1040,
© Dynamic Solutions Worldwide, LLC
Chapter 1, Subchapter J, Radiological health.
® customer service at
120 V~ 60 Hz 35 W