DynaTrap DT1750 Manual Del Propietário

DT1750
OWNER'S MANUAL
Thank you for purchasing
the DYNATRAP Insect Trap!
®
This product may be covered by one or more U.S. patents
or pending patent applications. See www.DynaTrap.com/patents
IMPORTANT: READ CAREFULLY
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
WARNING:
when using electric appliances, basic precautions should
always be followed, including the following:
1. Please read all instructions before using the DynaTrap Insect Trap and keep for future reference.
®
2. To disconnect, turn all controls to the off ("O") position, then remove plug from outlet.
3. To reduce the risk of injury from moving parts or electric shock, always turn unit off and disconnect plug before
servicing or cleaning.
4. Always unplug before replacing lamp. Replace with same type rated 6-Watt bulbs, DynaTrap
5. Do not position the unit near heat, gas, oil or other flammable materials.
6. Place out of reach from children.
7. To reduce the risk of electrical shock, do not put appliance in water or other liquid.
8. Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or if it has been dropped into water or other liquid.
9. Connect only to a circuit that is protected by a ground-fault circuit-interrupter (GFCI).
10. Do not insert fingers or any foreign objects into the unit while it is connected to an electrical outlet.
11. Collected insects within the unit may contribute to fire, so clean insects from the unit frequently.
12. Do not clean this product with water spray. Do not place where it can fall into water, or near flammable materials.
13. Do not touch fan while in motion.
14. Do not abuse cord—never carry or hang unit by cord or yank it to disconnect from receptacle.
Keep cord away from sharp edges.
15. If using outdoors, use only extension cords with a tag stating, "Suitable for Use with Outdoor Appliances."
16. Use only extension cords that have plug and receptacles that match the product plug.
Replace or repair damaged cords.
17. Only use attachments recommended or sold by the manufacturer.
18. This appliance is provided with double insulation. Use only identical replacement parts.
See instructions or Servicing of Double-Insulated Appliances.
IINSTALLATION & OPERATING INSTRUCTIONS
1. Unpack unit. Save carton for off-season storage (if needed).
2. If hanging the unit, place approximately 3-6 feet above the floor/ground level for optimal catch rate and easy
access for cleaning. Unit can also be placed on the floor or ground.
3. Plug cord into an outdoor outlet or extension cord as described in "IMPORTANT SAFETY INSTRUCTIONS".
4. Turn power switch to "ON" postion. The switch is located under the upper housing on the outer rim.
5. For best catch results leave unit on at all times, except when cleaning or servicing.
6. Catch rate activity will be higher at night. For best catch results it is recommended to keep the unit away from
competing light sources.
7. It is recommended to place the unit at least 20 to 40 feet away from your outdoor living area.
8. This unit is all-weather resistant - designed for outdoor use including rainy conditions. Intended for household use only.
9. To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other).
This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
10. SERVICING OF DOUBLE-INSULATED APPLIANCES - In a double-insulated appliance, two systems of insulation are
provided instead of grounding. No grounding means is provided on a double-insulated appliance, nor should a means
for grounding be added to the appliance. Servicing of a double-insulated appliance requires extreme care and
knowledge of the system and should be done only by qualified service personnel. Replacement parts for a double-
insulated appliance must be identical to those parts in the appliance. The symbol must be identical to those parts in
the appliance. A double-insulated appliance is marked with the words "DOUBLE INSULATION", "DOUBLE-INSULATED"
or the symbol:
CLEANING
Frequent cleaning will prolong the life of the unit, ensure fire prevention and provide for more efficient operation.
1. Be sure to clean the unit once per week
2. Switch the unit off and unplug before cleaning
3. Twist the cage clockwise. Remove any buildup from the inside of the retaining cage.
4. Clean before off-season storage.
IMPORTANT: When replacing the retaining cage – DO NOT press/push against the screen windows.
REPLACING BULB Replace With DynaTrap Bulb #43050 (or equivalent G24ype - 120V/26W Bulb)
The light bulb life expectancy is approximately 3,000 hours (or about 4 months), and should be replaced regularly to
ensure optimal UV effectiveness. Even though the bulb's light may be visible to you, its ability to attract insects diminishes
over time.
1. Turn power switch to "off" position. UNPLUG UNIT, and allow bulb to cool before replacing.
Turn the unit upside down.
2. Twist the black threaded fastener piece securing the light housing counter clockwise to loosen. Move the light
housing to the side.
3. Twist the two black threaded fastener pieces securing the light and carefully remove the silver clips.
4. Cover the bulb with a cloth to protect your fingers and hand. Grasp the bulb (with your hand and fingers protected
by the cloth) and gently pull the bulb from the socket.
5. Remove any debris from the lamp socket with a brush before inserting the new bulb. Insert new replacement bulb.
Place metal clips in place and secure black threaded fasteners.
6. Twist the light housing clockwise into place and secure the black threaded fastener.
model 43050.
®
HOW THE DYNATRAP INSECT TRAP WORKS
®
Flying insects are attracted to the unit by the UV light and CO2 that is generated by the photo-catalysis between the
UV lamps and the special TiO2 coating. The fan then pulls the insects into the screened base, trapping them until they
dehydrate and die. The base can be removed, allowing the contents to be periodically emptied into the trash. Monitor
the insects trapped in the retaining cage, through the see-through screen, and empty when compartment becomes full.
ON/OFF
SWITCH
FAN
RETAINING
CAGE
TROUBLESHOOTING
Problem:
Bulb does not illuminate
and fan does not spin.
Bulb illuminates, but fan
does not spin.
Fan spins, but bulb does not
illuminate.
LIMITED WARRANTY
DYNAMIC warranties to the original purchaser that this product is free from defective materials and workmanship.
This warranty is limited to remedy any defective part for a period of one year from date of original date of purchase.
Retain your original receipt as proof of purchase. This warranty does not apply to the light bulb, nor to, in our
judgment, misuse or abuse. If this unit has been altered, no warranty is in force. This warranty does not apply if this
unit is purchased outside the United States, excluding Canada and Mexico. In no case shall DYNAMIC be liable for
any accidental, punitive, consequential, or any other damages of any kind for breach of this or any other warranty,
expressed or implied, whatsoever. Some states do not allow limitation on how long an implied warranty lasts, so the
above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also
have other rights that vary from state to state.
REPLACEMENT PARTS
43050 26-Watt UV Replacement Bulb (1 piece)
To see all replacement and accessory parts available for your DynaTrap visit www.DynaTrap.com.
FOR HOUSEHOLD USE ONLY
HANGER
INTERRUPTOR PARA
UV BULB
PRENDER O
APAGAR
TiO COATED
2
SURFACE
LIGHT
Dynamic Solutions Worldwide, LLC
ENHANCING
VENTILADOR
U.S.A. & Canada
DIFFUSER
12247 W. Fairview Ave. Milwaukee, WI 53226
1-877-403-TRAP (8727)
customercare@dsw-llc.com | www.DynaTrap.com
Mexico
CAMARA DE
RECOLECCION Dynatrap Servicios de Mexico S. de R. L. de C.V.
FUNNEL
01-800-880-8727 | servicios@dsw-llc.com
©2019 Dynamic Solutions Worldwide, LLC
Possible cause: Correction:
No electrical power. 1.Check plug, receptacle, and fuse or circuit breaker.
Shorted fan. 1.UNPLUG UNIT: Examine fan to see that it is free from
foreign material, dirt or buildup of dead insects.
2. Clean unit as in "CLEANING" section.
1. Bulb not seated 1. Check all sockets for proper bulb seating and alignment.
properly 2. Replace bulb if needed following instructions under
2. Burnt out bulb "Replacing Bulb"
GANCHO
PARA COLGAR
FOCO
ULTRAVIOLETA
SUPERFICIE CON
CAPA DE TiO2
LUZ
MEJORANDO
DIFUSOR
4008295
EMBUDO
This device complies with Performance Standards
for Light-Emitting Products, 21 DFR, Part 1040,
Chapter 1, Subchapter J, Radiological health.